China the switching frequency of the AC-DC switching power supply module?(3)
(3) Before the installation is completed and the power is turned on, the wiring on each terminal should be checked and checked again to ensure that the input and output, AC and DC, single-phase and multi-phase, positive and negative, voltage and current values are correct. Prevent the occurrence of reverse and wrong connections.
(4) For high-power power supplies, there are generally two or more "+" output terminals and "-" output terminals. In fact, they belong to the same output electrode, but for the convenience of user wiring, they are connected together internally.
(5) The module power supply is not allowed to work at full load for a long time. The utilization rate of linear power supply should be controlled within 60%; the utilization rate of switching power supply should be controlled within 80%, otherwise it may cause early artificial failure of module power supply.
We know that the lower the switching frequency, the smaller the switching loss, but on the other hand, with the reduction of the switching frequency, the volume of the Marine boost power supply equipment will be reduced to the maximum, which is not conducive to miniaturization. When the switching Marine boost power supply is working, due to the switching of the switching device, the magnetic core will vibrate, and the frequency range that the human ear can hear is about 20~20000Hz. In order to avoid audible noise, we usually choose to stay away from the 20 frequency KHz.
2. China Disadvantages of choosing an AC-DC control IC with a switching frequency higher than 135K
When testing electronic and electrical equipment, the electronic and electrical equipment shall be tested for conducted interference voltage emission at its Marine boost power supply terminal. Although the test frequency bands of different standards are different, the test frequency bands of most products are 150K~30M. It can be seen from the lower limit of the test frequency that the operating frequency of the switching Marine boost power supply is close to 150K, and the more difficult it is to deal with the conducted disturbance.