Tajikistan acdc power module potting requirements(2)

Regulation of output voltage
For module power products with TRIM or ADJ (adjustable) output pins, the output voltage can be adjusted within a certain range through resistors or potentiometers, and the general adjustment range is ±10%.
For the TRIM output pin, connect the center of the potentiometer to TRIM. In all modules with +S and -S pins, the other two ends are connected to +S and -S respectively. When there is no +S, -S, connect the two ends to the output positive and negative poles of the corresponding main circuit (+S to +Vin, -S to -Vin), and then adjust the potentiometer. The resistance value of the potentiometer is generally more appropriate to use 5 ~ 10kΩ.

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad 24V input power supply manufacturers also use this epoxy resin acdc 24V input power supply module. However, due to stress problems, the failure rate of this 24V input power supply is very high, and buyers are miserable.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.