Grenada acdc power module potting requirements(1)

For the ADJ output pin, it is divided into input side adjustment and output side adjustment. The output side is adjusted in the same way as the TRIM pin. The input side adjustment can only increase the output voltage. At this time, one end of the potentiometer is connected to the center, and the other end is connected to the ground of the input end.

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad 48V input power supply manufacturers also use this epoxy resin acdc 48V input power supply module. However, due to stress problems, the failure rate of this 48V input power supply is very high, and buyers are miserable.