Noise pollution has always been a major problem for manufacturers. In the early days, machinery and equipment would generate a lot of noise during wor

There are three elements in the procurement of on-board DCDC, Vietnam and the noise should not be too largeThe distributed power supply mode has the

In the early 1980s, the research on the distributed high frequency switching power supply system basically focused on the research of the converter pa

The core problem of the Marine boost/buck voltage power supply is the IC, which is like the brain of the Marine boost/buck voltage power supply. The

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, d

The quality of the resolution of the circuit schematic is usually done from a professional perspective. This power module can be divided into two kind

For control in the on-board DCDC products with TRIM or ADJ (adjustable) output pins, the output voltage can be adjusted within a certain range throug

When testing electronic and electrical equipment, the electronic and electrical equipment shall be tested for conducted interference voltage emission

Internationally, the inverter power supply series products below 400kVA have come out. In the early 1980s, Toshiba Corporation of Japan was the first

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (w

The switching power supply module, in short, is to obtain a higher power wholesale supply through some modifications. In fact, the internal circuit o

Noise pollution has always been a major problem for manufacturers. In the early days, machinery and equipment would generate a lot of noise during wor