Saudi Arabia There are three elements in the procurement of on-board DCDC(1)

There are three elements in the procurement of on-board DCDC, Saudi Arabia and the noise should not be too large

In order to improve the work efficiency of enterprises, provide the performance of enterprise products, and gain a firm foothold in the market, many enterprises now use on-board DCDC in mechanical products to ensure that the equipment will work without any problems. However, when it comes to the procurement of on-board DCDC, experts say there are three elements that companies must be aware of.

1. The noise should not be too loud.

For the ADJ output pin, it is divided into input side adjustment and output side adjustment. The output side is adjusted in the same way as the TRIM pin. The input side adjustment can only increase the output voltage. At this time, one end of the potentiometer is connected to the center, and the other end is connected to the ground of the input end.

Noise pollution has always been a major problem for manufacturers. In the early days, machinery and equipment would generate a lot of noise during work, which would affect the health of employees. According to the senior human resources department, it is very difficult to recruit workers at the moment. With the rise of Internet recruiting, it is easier for people to find jobs, but we are reluctant to work in production. If businesses cannot address noise pollution, they may not even find workers. After all, people these days take their health very seriously.