What is the role of the control in the on-board DCDC?(2)
rectangular wave of 20 kHz.
Due to the poor working conditions of the welding machine power supply and frequent short-circuit, arcing and open-circuit changes, the working reliability of the high-frequency inverter rectifier welding machine power supply has become the most critical issue and the most concerned issue by users. . The microprocessor is used as the relevant controller of pulse width modulation (PWM), and through the extraction and analysis of multi-parameter and multi-information, the purpose of predicting various working states of the system is achieved, and then the system is adjusted and processed in advance to solve the problem. The reliability of high-power IGBT inverter power supply is improved.
Foreign inverter welding machines can achieve a rated welding current of 300A, a load duration rate of 60%, a full-load voltage of 60~75V, a current adjustment range of 5~300A, and a weight of 29kg.
For the TRIM output pin, the center of the output potentiometer and the center TRIM are all connected to +S, -S in the pin module, and the other two ends are connected to +S, -S respectively. There is no +S, and the -S ends receive the positive and negative outputs of the corresponding main circuit respectively (+S is connected to +Vin, -S is connected to -Vin), and then adjust the potentiometer. The resistance of the potentiometer is generally 5~10kΩ.
control in the on-board DCDC The ADJ output pins are divided into input adjustment and output adjustment. Output trim and output trim. The adjustment method of the TRIM pin is the same. When one end of the potentiometer is connected to the center, the output voltage can only increase the output voltage, and the other end is connected to the ground of the input.
Input protection circuit General switching LED advertising screen power supply module supply products use built-in filters, which can meet the requirements of general LED advertising screen power supply applications. If a more demanding power system is required, control in the on-board DCDC the input filter network should be added. Either LC or π can be used but care should be taken to choose a smaller inductance and larger capacitance.