What is the role of the supplier?(2)

For the TRIM output pin, the center of the output potentiometer and the center TRIM are all connected to +S, -S in the pin module, and the other two ends are connected to +S, -S respectively. There is no +S, and the -S ends receive the positive and negative outputs of the corresponding main circuit respectively (+S is connected to +Vin, -S is connected to -Vin), and then adjust the potentiometer. The resistance of the potentiometer is generally 5~10kΩ.

supplier The ADJ output pins are divided into input adjustment and output adjustment. Output trim and output trim. The adjustment method of the TRIM pin is the same. When one end of the potentiometer is connected to the center, the output voltage can only increase the output voltage, and the other end is connected to the ground of the input.

power source is realized through the power transfer switch.
Modern UPS generally adopts pulse width modulation technology and modern power electronic devices such as power MOSFET, IGBT, etc., the noise of power supply can be reduced, and the efficiency and reliability can be improved. The introduction of microprocessor software and hardware technology can realize intelligent management of UPS, remote maintenance and remote diagnosis.
The maximum capacity of the online UPS can be made to 600kVA. The development of ultra-small UPS is also very rapid, and there are already 0.5kVA, lVA, 2kVA, 3kVA and other products of various specifications.

Input protection circuit General quotation supply products use built-in filters, which can meet the requirements of general Marine boost/buck voltage power supply applications. If a more demanding power system is required, supplier the input filter network should be added. Either LC or π can be used but care should be taken to choose a smaller inductance and larger capacitance.