What does a power supply converter look like?(4)
Electrolytic capacitors, as well as monolithic electrolytic capacitors, which use sulfuric acid as the insulating medium, which allows for greater capacity savings, are made into smaller volumes, and are marked with a + symbol, some with an a symbol. Typically used for low frequency crosslinking and bypass filtering. The disadvantage is that the loss of mesons is greater. Monolithic electrolytic capacitors are due to their special properties. The performance of the material is better than that of ordinary electrolytic capacitors, and the frequency characteristics are better, but the capacity cannot be too large, and can be used in precision circuits and timing circuits.
power supply converter Ceramic capacitors include ceramic dielectric capacitors, ceramic chip capacitors, ceramic tube capacitors and ceramic semi-variable capacitors. It is mainly non-polar, the dielectric material is better, and the capacity cannot be too large, suitable for high frequency circuits.
Five: Batch inspection and high temperature aging test
power source is realized through the power transfer switch.
Modern UPS generally adopts pulse width modulation technology and modern power electronic devices such as power MOSFET, IGBT, etc., the noise of power supply can be reduced, and the efficiency and reliability can be improved. The introduction of microprocessor software and hardware technology can realize intelligent management of UPS, remote maintenance and remote diagnosis.
The maximum capacity of the online UPS can be made to 600kVA. The development of ultra-small UPS is also very rapid, and there are already 0.5kVA, lVA, 2kVA, 3kVA and other products of various specifications.
Regardless of how much control the product material and production process are, aging needs to be checked. Because the incoming inspection of electronic components and transformers is difficult to control, the quality stability of this batch of power supplies and whether the materials are detected to have potential safety hazards can only be detected through aging and high-temperature sampling of the entire batch of power supplies.