Bangladesh acdc power module potting requirements(2)

power source is realized through the power transfer switch.
Modern UPS generally adopts pulse width modulation technology and modern power electronic devices such as power MOSFET, IGBT, etc., the noise of power supply can be reduced, and the efficiency and reliability can be improved. The introduction of microprocessor software and hardware technology can realize intelligent management of UPS, remote maintenance and remote diagnosis.
The maximum capacity of the online UPS can be made to 600kVA. The development of ultra-small UPS is also very rapid, and there are already 0.5kVA, lVA, 2kVA, 3kVA and other products of various specifications.

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost voltage power supply manufacturers also use this epoxy resin acdc Marine boost voltage power supply module. However, due to stress problems, the failure rate of this Marine boost voltage power supply is very high, and buyers are miserable.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.