What does a DCDC conversion module look like?(4)

Electrolytic capacitors, as well as monolithic electrolytic capacitors, which use sulfuric acid as the insulating medium, which allows for greater capacity savings, are made into smaller volumes, and are marked with a + symbol, some with an a symbol. Typically used for low frequency crosslinking and bypass filtering. The disadvantage is that the loss of mesons is greater. Monolithic electrolytic capacitors are due to their special properties. The performance of the material is better than that of ordinary electrolytic capacitors, and the frequency characteristics are better, but the capacity cannot be too large, and can be used in precision circuits and timing circuits.

input protection circuit
General module power products have built-in filters, which can meet the requirements of general power supply applications. If a more demanding power system is required, an input filter network should be added. An LC or π-type network can be used, but care should be taken to choose a smaller inductance and larger capacitance as much as possible.
In order to prevent the transient high voltage of the input power supply from damaging the power supply of the module, it is recommended that the user connect a transient absorption diode at the input end and use it with a fuse to ensure that the module is within a safe input voltage range. In order to reduce common-mode noise, Y (Cy) capacitors can be added, and a few nf high-frequency capacitors are generally selected. R is a fuse, D1 is a protection diode, and D2 is a transient absorption diode (P6KE series).

DCDC conversion module Ceramic capacitors include ceramic dielectric capacitors, ceramic chip capacitors, ceramic tube capacitors and ceramic semi-variable capacitors. It is mainly non-polar, the dielectric material is better, and the capacity cannot be too large, suitable for high frequency circuits.

Five: Batch inspection and high temperature aging test

Regardless of how much control the product material and production process are, aging needs to be checked. Because the incoming inspection of electronic components and transformers is difficult to control, the quality stability of this batch of power supplies and whether the materials are detected to have potential safety hazards can only be detected through aging and high-temperature sampling of the entire batch of power supplies.