What does a 110V input power supply look like?(4)

Electrolytic capacitors, as well as monolithic electrolytic capacitors, which use sulfuric acid as the insulating medium, which allows for greater capacity savings, are made into smaller volumes, and are marked with a + symbol, some with an a symbol. Typically used for low frequency crosslinking and bypass filtering. The disadvantage is that the loss of mesons is greater. Monolithic electrolytic capacitors are due to their special properties. The performance of the material is better than that of ordinary electrolytic capacitors, and the frequency characteristics are better, but the capacity cannot be too large, and can be used in precision circuits and timing circuits.

high frequency switch
The rapid development of the communication industry has greatly promoted the development of communication power. High frequency miniaturized switching power supply and its technology have become the mainstream of modern communication power supply system. In the field of communication, the rectifier is usually called the primary power supply, and the direct current-direct current (DC/DC) converter is called the secondary power supply. The role of the primary power supply is to convert the single-phase or three-phase AC power grid into a DC power supply with a nominal value of 48V. In the primary power supply for program-controlled switches, the traditional phase-controlled regulated power supply has been replaced by a high-frequency switching power supply. Controlled in the 50-100kHz range for high efficiency and miniaturization. In recent years, the power capacity of switching rectifiers has been continuously expanded, and the single-unit capacity has been expanded from 48V/12.5A, 48V/20A to 48V/200A, 48V/400A.

110V input power supply Ceramic capacitors include ceramic dielectric capacitors, ceramic chip capacitors, ceramic tube capacitors and ceramic semi-variable capacitors. It is mainly non-polar, the dielectric material is better, and the capacity cannot be too large, suitable for high frequency circuits.

Five: Batch inspection and high temperature aging test

Regardless of how much control the product material and production process are, aging needs to be checked. Because the incoming inspection of electronic components and transformers is difficult to control, the quality stability of this batch of power supplies and whether the materials are detected to have potential safety hazards can only be detected through aging and high-temperature sampling of the entire batch of power supplies.