The Commonwealth of Dominica acdc power module potting requirements(2)

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad 48V input power supply manufacturers also use this epoxy resin acdc 48V input power supply module. However, due to stress problems, the failure rate of this 48V input power supply is very high, and buyers are miserable.

(2) Parallel connection of redundant hot backup. Connecting the output terminals of the same module through diodes in parallel can enhance the output capability and improve the reliability of the power supply system. In principle, if it cooperates with the corresponding output alarm circuit, put the module on the busbar that can be removed, so that the faulty module can be replaced in time. There is no limit to the number of modules connected in parallel in this way. D is generally a Schottky diode.
(3) Series expansion. Connecting the output terminals of the same module in series can double the output voltage and increase the power accordingly, and the series output terminals must be connected with diodes for protection.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.