Iran the switching frequency of the AC-DC switching power supply module?(5)

Remote control switch circuit
The remote control switch operation of the module power supply is carried out through the REM terminal. There are two general control methods:
(1) REM is connected to -VIN (reference ground), the remote control is turned off, and VREF<0.4V is required. REM is suspended or connected to +VIN, the module works, and VREM>1V is required.
(2) REM is connected to VIN, the remote control is turned off, and VREM<0.4V is required. REM is connected to +VIN, the module works, VREM>1V is required. REM is suspended, and the remote control is turned off, that is, the so-called "suspended shutdown" (-R).
If the control is to be isolated from the input, an optocoupler can be used to pass the control signal

At present, the power carrier is mainly used for intelligent carrier in the home, remote meter reading system, and remote street lamp control system. The use range of the carrier frequency of power lines in my country is 9KHz ~ 500KHz, and the carrier bandwidth is 4KHz. The development of power carrier is very limited due to the change of power line impedance and the interference of power line noise. In order to increase the communication distance of the power carrier, we must move away from the power switching frequency of the circuit carrier unit. The carrier frequencies currently used in China are 115KHz and 132KHz. In this case, the switching frequency is around 60KHz for the Marine boost voltage power supply.