Thailand acdc power module potting requirements(1)

Regulation of output voltage
For module power products with TRIM or ADJ (adjustable) output pins, the output voltage can be adjusted within a certain range through resistors or potentiometers, and the general adjustment range is ±10%.
For the TRIM output pin, connect the center of the potentiometer to TRIM. In all modules with +S and -S pins, the other two ends are connected to +S and -S respectively. When there is no +S, -S, connect the two ends to the output positive and negative poles of the corresponding main circuit (+S to +Vin, -S to -Vin), and then adjust the potentiometer. The resistance value of the potentiometer is generally more appropriate to use 5 ~ 10kΩ.

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost power supply manufacturers also use this epoxy resin acdc Marine boost power supply module. However, due to stress problems, the failure rate of this Marine boost power supply is very high, and buyers are miserable.