Saint Vincent and the Grenadines acdc power module potting requirements(2)

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad LED advertising screen power supply manufacturers also use this epoxy resin acdc LED advertising screen power supply module. However, due to stress problems, the failure rate of this LED advertising screen power supply is very high, and buyers are miserable.

Due to the wide variety of integrated circuits used in communication equipment, their power supply voltages are also different. In the communication power supply system, a high-frequency DC-DC isolation module power supply with high power density is used, which is converted from the intermediate bus voltage (usually 48V DC) to Various DC voltages are required, which can greatly reduce losses, facilitate maintenance, and are very convenient to install and increase. Generally, it can be directly installed on the standard control board, and the requirement for the secondary power supply is high power density. Due to the continuous increase of communication capacity, the capacity of communication power supply will also continue to increase.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.