Cuba acdc power module potting requirements(1)

reasonable core structure and compact structure.
At the same time, in order to reduce the size of the module switching power supply, the switching frequency of the module switching power supply should be increased as much as possible. If it is to be increased to about 500kHz or higher, the loss of the ordinary magnetic core material is very large, and the magnetic core is easily overheated and magnetically saturated, and even It cannot work normally, so the high-frequency magnetic core material with excellent magnetic properties must be selected in the module switching power supply.

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad 24V input power supply manufacturers also use this epoxy resin acdc 24V input power supply module. However, due to stress problems, the failure rate of this 24V input power supply is very high, and buyers are miserable.